A SERVICE OF

logo

stp-path-priority
[Port Priority]
Interface
configuratio
n mode
Use the
spanning-tree
port-priority
interface
configuration
command to
configure a port
priority that is used
when two switches
tie for position as
the root switch.
Use the no form of
this command to
return to the
default value.
128
Switch (config)#
interface fastEthernet
0/2
Switch (config-if)#
stp-path-priority 127
3.3.2.6 QoS Commands Set
Commands
Command
Level
Description Defaults Example
qos storm-control
[5|10|15|20|25| off
(%)] or no
storm-control
Global
configuratio
n mode
Enable/Disable
broadcast storm
control. Use the no
form of this
command to
restore to default.
OFF
Switch (config)# qos
storm-control 5
qos
low-priority-delay-b
ound [on|off] [sec.]
or no qos
low-priority-delay-b
ound
Global
configuratio
n mode
Enable/Disable
low priority delay
board.
Use the no form of
this command to
restore to default.
OFF
Switch (config)# qos
low-priority-delay-boun
d on 1