Event
39
Use the following procedure to configure settings the control alarm action when a terminal alarm occurs.
For information on how to register preset positions for the camera, refer to the Operating Instructions.
1 Click the [Event] button on the setup menu.
2 On the sub-menu that appears, click [Terminal alarm].
This will display the terminal alarm setting window.
3 Configure the settings for each item.
Refer to “Terminal alarm settings” table for details about the
settings.
• To configure the settings of a terminal that is not shown
on the display, click the terminal number range above the
[Set] button to change the contents of the window.
• Clicking a terminal number range will save the currently
displayed camera settings.
4 Click the [Set] button.
Terminal alarm settings
♦Initial default
Terminal alarm
Item Settings Description
Rec. cam. Cam.1 to Cam.64 / -- Specifies the channel of the recording camera.
Preset position Number input
(Blank♦)
Specifies the preset position (1 to 256) during alarm input.
• When this setting is blank, the camera does not move to a
preset position.
Output terminal Off / On♦ Specifies whether an alarm signal should be output when an
event occurs.
