Commander GP User Guide
Issue code: gpxu2
1-4 Introduction
1.8 Plug-in option modules
Operation of the Drive can be extended by the use
of plug-in option modules. The following modules
are available from the supplier of the Drive; an
appropriate User Guide is included with each
module:
Small option modules
UD50 Additional I/O
UD55 Cloning (parameter copying)
Large option modules
UD71 RS232/RS485 serial
communications
1.9 Serial communications
The Drive can be configured and fully controlled
from a system controller or PLC operating on a
RS232 or a 4-wire RS485 serial communications link.
A Basic serial communications large option module
must be fitted in the Drive. More information can
be obtained from a Drive Centre or distributor
listed at the end of this User Guide.
Serial communications can be used in conjunction
with Terminal mode or Keypad mode.
