30
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
SEC
AGN
AIW
SEC
SEC
WALL PANEL INSTALLATION
Fold Corner Wall Panel 105 (AGN). Fit tabs of Panel into the front, left corner of your Floor (while facing shed). Place
a Wood Block (AIW) under the fl oor panel, directly under the fi rst tab, then pull down on the Corner Wall Panel until
the tab snaps into place. Move the Wood Block under the next tab and repeat.
Note: A second person should apply pressure on opposite side of the Wall
Panels for easier insertion of the Screw. Do not overtighten Screw.
!
ADZX
Note: Place the Wood Block (AIW) directly under the tabs as you insert
them throughout the assembly. Snap tabs into place one at a time.
!
AHD
AHD
AHH
ADZ
AIW
Snap two Wall Panels (AHD) and a Window Wall Panel (AHH) into place along the left side of the shed. The Window Wall
Panel may be inserted in any side Wall Panel position. Ensure the tops of the Wall Panels are even and the holes align.
Insert a 1/4” x 5/8” Pan-Head Screw (ADZ) through the top hole of each set of Panels to fasten the Panels together as
SHOWN9OULLlNISHFASTENINGTHEPANELSTOGETHERTOWARDSTHEENDOFTHISSECTION
AIW (x1)
Wood Block
4
4.1
4.2
