A SERVICE OF

logo

Open as PDF
next previous
3-6
Configuring the Switch
Configurable Features
Configuring the Switch
Port Features
Configures the operating state for each port and optionally assigns selected
ports to a port trunk. (For more on port trunking, refer to chapter 7.) Also
optionally enables you to restrict the amount of broadcast traffic on the port.
The read-only fields in this screen display the port names and port types.
Figure 3-5. Example of the Port Configuration Screen
Port names in the configuration correspond to port number on the front of the
switch.
Note Broadcast limit (the Bcast Limit parameter) can be set for all ports in the
switch (or VLAN, if VLANs are configured) from the Automatic Broadcast
Control (ABC) screen (page 7-30 and following) if ABC is enabled. Setting the
broadcast limit (Bcast Limit) in the above screen is on a per-port basis and
overrides any settings done in Automatic Broadcast Control.
Read-Only Fields
SEDONA.BK : sed_3.fm5 Page 6 Thursday, February 27, 1997 10:11 AM