1-4
Installation
1. Install Add-In Transceivers (Optional)
Installation
It may be more convenient to install additional transceivers before installing
the Switch 800T into a rack or other location. Inspect your installation site and
determine whether the switch’s module slots will be accessible.
For a description of currently available transceivers, contact your
HP-authorized LAN dealer or check Hewlett-Packard’s World Wide Web site
listed on the card at the front of this manual.
To Install a Transceiver into the Switch 800T: This procedure
describes the general installation of a transceiver. For information on the
specific transceiver you are installing, plus specific connection and trouble-
shooting information, refer to the HP 100Base-T Transceiver Modules
Installation Guide you received with the transceiver.
1. Unplug the Switch 800T from the AC power source.
Caution To avoid damage to circuitry in the Switch 800T and transceivers,
always have the power to the Switch 800T turned off while a
transceiver is being installed or removed.
2. Use a flat-bladed or Torx T-10 screwdriver to unscrew the two retaining
screws from the cover plate on the slot in which you want to install the
transceiver. For example, to install an HP J3192B AdvanceStack 100Base-
TX Twisted-Pair Transceiver Module for port 5:
Figure 1-2. Remove the Cover Plate from the Transceiver Slot
Retain the cover plate for future use. If you remove a transceiver in the
future without replacing it, cover the unused slot with one of these cover
plates.
Loosen These Screws
SEDONA.BK : sed_1.fm5 Page 4 Thursday, February 27, 1997 10:11 AM
