7-34
Advanced Concepts
Automatic Broadcast Control (ABC)
Advanced Concepts
2. Select Automatic Broadcast Control (ABC) and press [Enter].
3. If no VLANs are configured, go to step 4 . If VLANs are configured, press
E
dit, then select the VLAN in which you want to configure ABC.
Note The rest of this procedure assumes that VLANs are not configured. If you have
VLANs configured on your switch, you can still use this procedure. The screen
layout will be different than shown here, but the parameters are the same.
4. Press [E] (for Edit).
Figure 7-19. The Default ABC Screen (No VLANs Configured)
5. Use the Space bar to enable ABC. Select one of these options:
• IP_IPX: Enables ABC for both the IP and IPX protocols.
• IP: Enables ABC only for the IP protocol.
• IPX: Enables ABC only for the IPX protocol.
• Disabled
6. If you want broadcast control disabled for IP RIP and/or IPX RIP and SAP
broadcasts, leave the remaining parameters set to No and go to step 7.
If you do want broadcast control for RIP or SAP broadcasts, press an
Note: This is the screen
layout when no VLANs are
configured. The screen has
a different appearance if
VLANs are configured.
SEDONA.BK : sed_7.fm5 Page 34 Thursday, February 27, 1997 10:11 AM
