Appendix D Philips GP Quick Reference Appendix D Philips GP Quick Reference
*) only PRINTER TYPE 1 *****) only PRINTER TYPE 3
D-5 D-6
Table 4: Vertical Form Handling
Escape Sequence Mnemonic Function
ESC = LTOF Load Top of Form
ESC J VTS Set Vertical Tabulation at Current Line
ESC K PLD Subscript
ESC L PLU Superscript
ESC M RLF Reverse Line Feed (default / inch)
1
6
ESC [ ; P2 s AGC/PCC AGC/PCC Procedure (Print Gap Control)
P2 = 0 : Automatic Gap Control
P2 = 1 : Print Gap for 1-ply copy
P2 = 2 : Print Gap for 2-ply copies
P2 = 3 : Print Gap for 3-ply copies
P2 = 4 : Print Gap for 4-ply copies
P2 = 5 : Print Gap for 5-ply copies
P2 = 6 : Print Gap for 6-ply copies
ESC [ < s EJF Eject Form
ESC [ > s IF Inset Form
ESC [ P1 h SM Set Mode - Select Paper Source *)
P1 = 2 0 : Tractor Feed (if selected at
operator panel) else AFS, Bin
3 (if selected at operator
panel) or Manual (if selected at
operator panel)
P1 = 2 1 : ASF, Bin 1
P1 = 2 2 : ASF, Bin 2
*) only PRINTER TYPE 1
**) only PRINTER TYPE 1 and PRINTER TYPE 2
****) only PRINTER TYPE 2 and PRINTER TYPE 3
***) only PRINTER TYPE 1 and PRINTER TYPE 3
Table 4: (Cont.) Vertical Form Handling
Escape Sequence Mnemonic Function
ESC [ P1 RM Reset Mode - Select Paper Source *)
P1 = 2 0 : Tractor Feed (if selected at
operator panel) else AFS, Bin
3 (if selected at operator
panel) or Manual (if selected at
operator panel)
P1 = 2 1 : ASF, Bin 1
P1 = 2 2 : ASF, Bin 2
ESC [ > P1; P2 ; P3 ; P4 s SPSIF Select Paper Source and Insert Form
P1 = 0 : Manual Feed **)
P1 = 1 : ASF, Bin 1 *)
P1 = 2 : ASF, Bin 2 *)
P1 = 3 : ASF, Bin 3 *)
P1 = 6 : upper Tractor ****)
P1 = 7 : Tractor Feed (lower Tractor)
P1 = 8 : ASF, Bins 1 or 2 *)
P1 = 9 : ASF, Bins 2 or 3 *)
P1 = 1 0 : ASF, Bins 1 or 2 or 3 *)
P1 = 1 5 : upper and lower tractor ****)
P2 = : see ACG/PCC above
P3 = 0 : Paper Exit Stacker ***)
P3 = 1 : Paper Exit Front Side *)
(confirmed by Start/Stop)
P3 = 2 : Paper Exit Front Side *)
(not confirmed by Start/Stop,
controlled by application)
P3 = 3 : Batch output; rear side
P4 Cut Mode On/Off: *****)
P4 = 0 : Cut Mode Off
P4 = 1 : Cut Mode On
P4 = 2 : Cut on actual position
(cutting edge is approximate 4 mm above the base of the actual line)
