Left Margin
Right Margin
Top Margin
Bottom Margin
8
Configuring the printer Configuring the printer
3-9 3-10
+/- 1 = +/- / " = +/- 0,42 mm
1
60
+/- 2 = +/- / " = +/- 0,85 mm
2
60
+/- 3 = +/- / " = +/- 1,27 mm
3
60
+/- 4 = +/- / " = +/- 1,69 mm
4
60
+/- 5 = +/- / " = +/- 2,12 mm
5
60
+/- 6 = +/- / " = +/- 2,54 mm
6
60
+/- 7 = +/- / " = +/- 2,96 mm
7
60
+/- 8 = +/- / " = +/- 3,39 mm
8
60
+/- 9 = +/- / " = +/- 3,81 mm
9
60
+/- 10 = +/- / " = +/- 4,23 mm
10
60
+/- 11 = +/- / " = +/- 4,66 mm
11
60
+/- 12 = +/- / " = +/- 5,08 mm
12
60
+/- 13 = +/- / " = +/- 5,50 mm
13
60
+/- 14 = +/- / " = +/- 5,93 mm
14
60
+/- 15 = +/- / " = +/- 6,35 mm
15
60
+ 16 = + / " = + 6,77 mm
16
60
- Vertical Positioning Adjustment (VERT.POS.ADJ.) - The right margin is set to print position 80, 132 or 136, always measured
This function changes the vertical position in the current macro for the five from the position of the first possible, not actual, left margin setting.
different paper paths TRACTOR V-POS ,MANUAL V-POS or BIN x V-POS
(x = 1 up to 3) exactly position the printout in relation to the top edge of the The left margin setting is influenced by the physical setting of the left tractor.
form in use. It is meant to be a corrective parameter to meet variations in The above specifications are only correct if the tractors are in the original
paper size and pre-printed material. Using this function, the TOP MARGIN positions, i.e. the left perforation is aligned with the centre mark on the plastic
and BOTTOM MARGIN setting are taken into account as well. plate (distance between the marks is / ").
This parameter covers a range of - / to + / of an inch, where "-" is up - The top margin indicates the first print line and is always set in steps of / ".
15 240
60 60
the page and "+" is further down the page. The position of the first margin is / " from the top of the paper and indicates
The following table shows some values in inch and millimetres.
Attention: The set up of VERT.POS.ADJ. will become effective at the next page
of the form. Therefore, it is recommended to perform
VERT.POS.ADJ. set up as long as the paper is in the park position
and before starting the print job.
- The left margin is set in / " steps, depending on the actual selection. The
1
10
first left margin position is / " from the left edge of the paper which means
1
20
that the letter H in regular "Data" font would be positioned / " from the left
1
20
edge of the paper. The left margin can be set to a maximum of / ".
15
10
1
10
1
6
1
6
the baseline of the letter H in upright "Data" font (see illustration).
The top margin can be set to a maximum of / " down on the paper.
16
6
