2
5
22
Getting Started Getting Started
1-17 1-18
- Select the paper source TRACTOR using either the menu selection of the - Move the left hand paper guide into the position indicated by ±• (22) on the
printer or your software (chapter 1.9). insertion guide. In this setting the margin has the smallest value possible.
- Initiate a printout (chapter 1.10), to check the margins. Readjust the tractors - Adjust the right hand paper guide to the width of the paper to be used.
until the printout appears within the desired margins.
1.8 Manual Sheet Insertion
Install the output stacker (5) into one of the two rails in the top cover (2).
The meaning of the two Positions:
- for paper with 80 g/m² or thicker use the steeper position (left picture);
- for thinner paper use the less inclined position (right picture).
- Check, if the manual sheet insertion is installed. Note: If continuous form paper is in print position on the platen and has not been
- Select MANUAL as the paper source using either the menu settings or your
software (see also chapter 1.9 Paper Source Selection).
teared off, it will be moved forward and TEAR OFF PAPER will be
displayed.
