638 802.1x Commands
The following table describes the significant fields shown in the display:
show dot1x ethernet
The show dot1x ethernet command has been modified to show the status of
MAC Authentication Bypass. This feature is an extension of Dot1x Option 81
feature added in Power Connect Release 2.1. to accept a VLAN name as an
alternative to a number when RADIUS indicates the Tunnel-Private-Group-
ID for a supplicant.
Syntax
show dot1x ethernet
interface
•
interface
— Specifies a valid interface number. The full syntax is unit/port
Default Configuration
There is no default configuration for this command.
Field Description
Interface The port number.
Username The username representing the identity of the Supplicant.
This field shows the username when the port control is
auto or mac-based. If the port is Authorized, it shows the
username of the current user. If the port is unauthorized it
shows the last user that was authenticated successfully.
Supp MAC Address The MAC-address of the supplicant
Session Time The amount of time, in seconds, since the client was
authenticated on the port.
Filter-ID The Filter Id assigned to the client by the RADIUS server.
This field is not applicable when the Filter-Id feature is
disabled on the RADIUS server and client.
VLAN Assigned The VLAN assigned to the client by the radius server.
When VLAN assignments are disabled, RADIUS server
does not assign any VLAN to the port, and this field is set
to 0.
