66 CHAPTER 3: GETTING STARTED
2 Select [1] Ethernet Port IP Configuration to display the Ethernet Port IP
Configuration menu, shown in Figure 37.
Figure 37 Ethernet Port IP Configuration Menu
3 Enter the following information (by selecting the appropriate options and
responding to the prompts that appear at the bottom of the screen) to enable IP
Ethernet connectors:
IP Address—Provided by the network administrator. This is the IP address of the
PathBuilder S330/S310 Management CPU.
You should consult the network administrator to obtain an IP Address for the
PathBuilder S330/S310 which will allow its 10BaseT Management port to co-exist
with hosts on its local LAN.
Subnet Mask—Provided by the network administrator.
Community Name—Enter
private (The community name applies to the SNMP
SET operation.)
Figure 38 shows a sample PathBuilder S330/S310 IP host setup.
Figure 38 Sample PathBuilder S330/S310 IP Host Setup
4 Select [4] Previous menu to return to the Local Host IP Configuration menu.
5 Select [2] Apply IP Configuration Changes to activate the IP address.
PathBuilder
S330/S310
192.73.30.99
192.73.30.100
3Com
Community
