146 CHAPTER 4: CONFIGURING PATHBUILDER S330/S310 MODULES, PORTS, AND APPLICATIONS
Figure 116 Configuring Side A of A VCM VCC Virtual Circuit
When you have entered a setting for each parameter, the Add Virtual Screen again
displays the list of PathBuilder S330/S310 modules and ports by slot number and
prompts you to enter a slot number for side B of the circuit, as shown in
Figure 117.
Figure 117 VCM VCC Add Virtual Circuit Screen with Side A Completed
4 Select the slot number corresponding to the module by which you are connected
to the network for side B of the circuit.
5 Repeat steps 3and 4 for side B of the circuit. The following prompt appears at the
bottom of the screen:
Is the above information correct (y/n)?
6 Enter y to confirm your configuration. Figure 118 shows a completed VCM VCC
circuit. As shown in the figure, the following message appears at the bottom of
the screen:
VC has been added.
Press any key to continue.
