Filter
Top Products
18
However, you may use the same heating
and cooling temperatures for consecutive
time periods. Also keep in mind that, for any
given day, you can only program one set of
times for both heating and cooling (for ex-
ample, if you select 5:00 AM to begin heat-
ing period 1 on Monday, then your cooling
period 1 for Monday will also begin at 5:00
AM). However, you may choose different
time periods for each day separately (for
example, heating/cooling period 1 on Mon-
day may begin at 5:00 AM, but heating/
cooling period 1 on Saturday may begin at
Heating Program for
ALL days of the Week:
Cooling Program for
ALL Days of the Week:
PERIOD TIME TEMP PERIOD TIME
TEMP
1
2
3
4
5:00 AM
9:00 AM
4:00 PM
10:00 PM
70
70
70
64
1
2
3
4
5:00 AM
9:00 AM
4:00 PM
10:00 PM
78
82
78
78
FACTORY PREPROGRAMMING CHART
Now look at the factory preprogrammed times
and temperatures shown at right. If this program
will suit your needs, simply press
RUN
PRGM
to begin
running the factory preset program.
If you want to change the preprogrammed times
and temperatures, follow these steps.
1. Determine the heating and cooling tempera-
tures you want to use. You may select up to
four heating temperatures (HEAT A, HEAT B,
HEAT C, and HEAT D), and up to four cooling
temperatures (COOL A, COOL B, COOL C,
and COOL D). Use the table on the following
page to write down the temperatures you
have selected.
2. Determine the time periods during which
you will program the temperatures you have
just selected. You must program four peri-
ods for each day (periods 1, 2, 3, and 4).