Filter
Top Products
Electrical connection
Electrical ground is required on this appliance.
Recommended groundlng method
For your personal safety, this appliance must bs
grounded. This air conditioner is equipped with a
power supply cord with a 3prong grounding
plug. To minimize possible electrical shock
hazard, the cord must be plugged into a mating
3prong grounding-type wall receptacle,
grounded in accordance with the National
Electrical Code (ANSI/NFPA 70-latest version)
and all local codes and ordinances. If a mating
3-prong groundingtype wall receptacle is not
available, it is the responsibilii of the consumer
to have a properly grounded 3-prong wall
receptacle installed by a qualified electrician.
Poww
Preparing for installation
Installation tips
For wood-frame cnement windowe: It may be
necessary to construct a frame, using at least
1 -inch thick wood, with a 15%inch wide opening.
Fasten frame securely and seal it into the
window opening.
For brick or cement bulkflng conetruction: It
may be necessary to provide a wood stool strip
under the air conditioner for mounting purposes.
Tools required
l Flat-head screwdriver
l Phillips-head screwdriver
l Carpenter’s level
l Tape measure
l Fine tooth saw
l Electric or hand drill
l %-inch drill bit
l %-inch drill bit
Pereonel Injury and
Product Damage Hazard
l Because this air conditioner weighs about
88 to 105 pounds, it is recommended that
you have someone help you when you
install your new unit and that you both use
proper lifting techniques.
l This appliance must be installed according
to all applicable codes and ordinances.
l Handle the air conditioner with care. Watch
out for the sharp metal fins on the front and
rear coils.
l Be sure your air conditioner does not fall
during installation.
l Do not use the water collected in the unit
for drinking purposes. lt is not sanitary.
Failure to follow the above precautions could
resull in personal injury or product damage.