Filter
Top Products
17
OPERATING INSTRUCTIONS
1) Remove rain shields.
1.
2.
5.
4.
6.
3.
MANUAL LIGHTING
ƽ DANGER
Failure to remove rain shields while igniting the
fi replace’s burners, or not waiting 5 minutes to allow
the gas to clear if the fi replace does not light, may
result in an explosive fl ame-up which can cause
serious bodily injury or death.
2) Make sure the burner control knob is turned OFF. (Push control knob
down and turn clockwise to ensure that it is in the OFF position.)
3) Turn the gas supply valve on.
ƽ WARNING: Do not lean over the open fi replace. Keep
your face and body at least one foot away from the
logs when lighting the fi replace.
4) Insert match holder with lit match near the center of the burner area.
5) Push in igniter several times, until burner is lit.
6) Check that the burner is lit.
ƽ WARNING: If the burner does not light, turn the
burner control knob to OFF and wait 5 minutes to let
the gas clear before you try again or try to light with a
match.
Note: Normal burning pattern will develop light soot on log set. If heavy
sooting occurs, refer to troubleshooting.
TO EXTINGUISH
Push in the burner control knob and turn clockwise to the OFF posi-
tion. Turn gas supply OFF at the source. When unit has cooled, replace
rain shields.