Filter
Top Products
44
© 2013 Directed. All rights reserved.
44
Button Auto Lock
When On, the remote control buttons lock if more than 20 seconds
lapses between button presses. If a button is pressed when locked, a
fault tone is emitted. To unlock the buttons; press the
button followed
by the
button, the buttons unlock and tones play to confirm.
Car Select
Car 2 must first be turned On (See Remote Features menu under “Pro-
gramming” on page 44 to turn on). Press and hold the
button
for 3 seconds. The remote flashes the LED and beeps once or twice to
indicate the selected Car is 1 or 2, release the button for Car Select
or continue to hold for programming.
Release the
button, then press and release while the LED and
beeps continue to perform Car Select. Once the car is selected a com-
mand can be performed by pressing one of the command buttons.
Programming
To enter: Press and hold the button for eight seconds, the remote
emits one long beep and turns the LED on, the programming main
menu has been accessed (see menu listings below).
To exit: Press and release the
button once, then press and hold the
button again. One short and one long beep is emitted for each
step back, the LED turns off when programming is exited.
1. Sensor Adjust
To avoid unintended alarm triggers, it is recommenced that an
authorized Directed dealer perform all sensor adjustments.
2. Remote Features menu
After entering the programming mode: Press and hold the
button, two LED flashes and beeps indicate the remote features