Filter
Top Products
50
PKGP-PRC001-EN
Additional Factory Installed
Options (FIOPS)
Electric Heaters
Factory installed and wired electric
heaters are available for all 3 phase
horizontal and downflow 12½ - 20 tons. If
ordering the Through the Base Electrical
option with an Electric Heater, the heater
must be factory installed.
Through the Base Electrical with Circuit
Breaker
This option is a factory installed thermal
magnetic, molded case, HACR Circuit
Breaker with provisions for through the
base electrical connections. The circuit
breaker will be installed in a water tight
enclosure in the unit with access through
a swinging door. Factory wiring will be
provided from the switch to the unit high
voltage terminal block. The circuit
breaker will provide overcurrent
protection, be sized per NEC and UL
guidelines, and be agency recognized by
UL/CSA. This option is available on all
12½-20 tons downflow models.
Powered or Unpowered Convenience
Outlet
This option is a GFCI, 120v/15amp, 2
plug, convenience outlet, either powered
or unpowered. When the convenience
outlet is powered, a service receptacle
disconnect will be available. The
convenience outlet is powered from the
line side of the disconnect or circuit
breaker, and therefore will not be
affected by the position of the disconnect
or circuit breaker. This option can only be
ordered when the Through the Base
Electrical with either the Disconnect
Switch, or Circuit Breaker, option is
ordered. This option is available on all
12½-20 tons downflow models.
Clogged Filter/Fan Failure Switch
A dedicated differential pressure switch
is available to achieve active fan failure
indication and/or clogged filter
indication. These indications will be
registered with either a zone sensor with
status indication lights or an Integrated
Comfort™ System.
Mechanical
Specifications
Reference or Comparative Enthalpy
Reference or Comparative Enthalpy
option shall be available when a factory
installed Downflow Economizer is
ordered. This option is available on all
12½-20 tons downflow models.
High Pressure Cutout
This option is offered for units that do
not have High Pressure cutout as
standard. The Voyager units with High
Pressure Cutout as standard are
WC*180-240B.
Hinged Access Doors
Sheet metal hinges are available factory
installed on the Filter/Evaporator Access
Door and the Compressor/Control
Access Door. This option is available on
all 12½-20 tons downflow models.
Trane Communications Interface (TCI)
An option for a factory installed Trane
Communication Interface is available to
allow twisted wire pair communication
with an Integrated Comfort ™ System.
Order this option when a combination of
TCI and oversized motor is desired.
Discharge Air Sensing Kit
This kit provides true discharge air
sensing in heating models. This sensor is
a status indicator readable through
Tracer™ or Tracker™. The kit is functional
only with the ReliaTel Options Module.
Coil Guards
Hail protection quality coil guards shall be
either factory or field-installed for
condenser coil protection.
High Efficiency Motors
This option is available with efficiency
ratings from 86.5 up to 91.0. It is not
available for all models.