Filter
Top Products
7 EN
Loading the remote controller batteries
a Remove the cover, and insert the batteries.
b Reattach the cover.
Removing the batteries
a Remove the cover, and take out the batteries.
b Reattach the cover.
* Please dispose of the batteries according to the local
regulation.
Batteries
• To replace the batteries, use two new batteries (AAA type).
• The batteries will last about one year under normal usage.
• Replace the batteries if there is no receiving beep from the indoor unit or when the air conditioner cannot be operated using the
remote controller.
• To avoid malfunctions due to battery leakage, remove the batteries when not using the remote controller for over one month.
• Slide off the cover while pressing the sides.
• Battery replacement
Be careful not to reverse the (+) position and the (–) position.
Setting the clock
Before you start operating the air conditioner, set the clock of the remote controller using
the procedures given in this section. The clock panel on the remote controller will
indicate the time regardless of whether the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote controller, the clock panel displays AM 0:00
and flashes.
a ON button (or OFF button)
Press the ON button (or OFF button) to set the current time.
Each press of the ON button (or OFF button) changes the time in one minute
increments.
Holding down the ON button (or OFF button) changes the time in ten minute
increments.
b SET button
Press the SET button.
The current time is displayed and the clock starts.
PREPARATION AND CHECK BEFORE USE
a
b
ON
OFF
ON
OFF
SET
SET