Filter
Top Products
9 EN
Location of the remote controller
• Keep the remote controller where its signals can reach the receiver of the indoor
unit (a distance of up to 7 m is allowed).
• When you select timer operation, the remote controller automatically transmits a
signal to the indoor unit at the specified time.
If you keep the remote controller in a location where proper signal transmission is
blocked, a time lag of up to 15 minutes may occur.
Remote controller holder
Installing the remote controller holder
• Before you actually install the remote controller holder on a wall or pillar, check
whether the remote controller signals can be received by the indoor unit.
Mounting and removing the remote controller
• To mount the remote controller, hold it parallel to the remote controller holder and
push it in fully. To remove the remote controller, slide the remote controller
upwards and out from the holder.
Types of signal receiving tones
When the receiver of the indoor unit receives a signal, a signal receiving tone is made from the indoor unit.
Beep ....................... Start/Change
Prolonged beep ...... Stop
Beep-beep .............. Notify
When the notification sound beep-beep is made
• This indicates that the temperature, fan speed, or air flow direction settings were returned to the basic settings.
USING THE REMOTE CONTROLLER
CAUTION
• The air conditioner will not operate if curtains, doors or other objects block the signals from the remote controller to the indoor
unit.
• Be careful that liquids do not spill onto the remote controller.
• Do not expose the remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not function properly.
Use curtains to prevent sunlight from reaching the receiver.
• Signals may not be properly received, if the room using the air conditioner has fluorescent lighting with electronic starters. If
you plan to use fluorescent lamps, consult with your local dealer.
• If other electrical appliances are activated by the remote controller, move these appliances or consult with your local dealer.
Item Basic setting
Temperature 22°C (8°C···8°C OPERATION (RAS-***-ND model only))
Fan speed AUTO
Horizontal air flow When the horizontal air flow louver faces the front.
Vertical air flow When the vertical air flow louver stops at the louver limit
position.
7 m