Toshiba HWS-1402H-E Heat Pump User Manual


 
106
Toshiba
2. Hydro unit Function Code Setting
2-1. How to set function code
<Procedure> Perform the following when no operation is in progress.
1 Press the SET and TEST and SELECT
buttons at the same time for 4 seconds or longer.
(See display )
2 Specify CODE NO. (FC) with the TEMP. button
for temperature setting.
3 Select a setting data with the TIME button for timer
setting.
The value in the DATA item changes.
4 Press the SET button. (If lights, the status is
confirmed)
To change the item to be set, go to 2.
5 Pressing the TEST button moves the unit to the normal
stop state.
2-2. How to set remote controller function code
This operation can set the start and end time of the nighttime low noise, anti bacteria, night set back, or other
functions.
<Procedure> Perform the following when no operation is in progress.
1 Press the TEST and CL and TEMP. buttons at
the same time for 4 seconds or longer. (See display )
appears on the left.
2 Specify CODE NO. (FC) with the TEMP. button
for temperature setting.
3 Select a setting data with the TIME button for timer
setting.
The value in the DATA item changes.
4 Press the SET button.(If the blinking changes to lit, the
status is normal)
To change the item to be set, go to 2.
5 Pressing the TEST button moves the unit to the normal
stop state.
2
3
45 1
2
3
4
15
+00A09-002_01EN_SVM_ALL_Air_to_Water.book Page 106 Monday, October 5, 2009 2:09 PM