Filter
Top Products
10
INSTALL STATIONARY PANEL
INSTALL ANCHOR BLOCKS
14
15
12
From exterior side of system, install
stationary panel by inserting top of
panel up into exterior channel in head
jamb.
Rotate bottom of panel in until inactive
door riser leg sets into groove.
Slide panel tightly against side jamb
Wipe off excess caulking.
As reference, the exterior side of the
panel is always the pre-finished side.
Insert anchor blocks into top and
bottom of inactive door panel.
Using a 1/8 drill bit, drill through
angled “toe-screw” hole into head
and sill.
Install #10 x 2 pan head screws
into “toe-screw” hole.
Fasten anchor block to panel with
#10 x 1 pan head screws.
"
½"
½"
Head
Sill
Anchor block
#10 x 1 pan head screw½"
#10 x 2 pan head screw½"
“toe-screw” hole
Exterior
Head Jamb
Sill
Exterior channel