Filter
Top Products
SEWING BUTTONHOLES
Preparation: Attach the buttonhole foot. Adjust the stitch length dial between
“0.5” - “1”. The density of the stitch depends on thickness of the fabric.
Note: Always test sew a buttonhole.
To prepare the fabric: Measure the diameter of the button and add 0.3 cm
(1/8”) for the bartacks. If you have a very thick button, add more to the diameter
measurement. Mark the position and length of the buttonhole on the fabric.
Position the fabric so that the needle is on the mark that is furthest from you. Pull
the buttonhole foot towards you as far as it will go. Lower the foot.
Sewing the buttonhole
1. Turn the pattern selector dial to
1
. Sew at moderate speed until you reach
the end mark.
2. Turn the pattern selector dial to
2
4
and sew 5-6 bartack stitches.
3. Now turn the selector dial to
3
. Sew the left side of the buttonhole to the
mark at the end furthest from you.
4. Turn the pattern selector dial to
2
4
and sew bar tack stitches.
Remove the fabric from under the foot. Draw the upper thread through the
reverse side of the fabric and knot upper and lower threads. Cut the centre of the
buttonhole with the seam ripper, being careful not to cut the stitches on either side.
Tips:
- Slightly reduce upper thread tension to produce better results.
- Use backing material for ne and stretchy fabrics.
- It is advisable to use a gimp cord for stretch or knit fabrics. The zigzag should
sew over the gimp. (5)
STITCH LENGTH DIAL
Page 23
BUTTONHOLE FOOT