Filter
Top Products
SECTION 1 IMPORTANT SAFETY INSTRUCTIONS
6
When you get this unit, please transport the product in an upright
position only, and place the product on an even surface. Remove the
cardboard box without turning it upside down, or laying it on its side.
Please note: If this unit is transported, it must be left in the
normal up right position for at least 8 hours before using, to
allow the coolant and compressor oil to settle.
a. Remove the adhesive tape on the top of the cardboard box.
b. Open the cardboard box.
c. Remove the Styrofoam packing and angle-protection board.
d. Lift and hold the unit from the Styrofoam packing base by using two
people, so as not to tilt the unit.
e. Remove the plastic bag.
f. Wipe it clean if necessary.
g. Then install hot air exhaust duct for condenser side according to the
installation instructions.
1.8 UNPACKING YOUR PRODUCT PARTS
Keep
upright
Figure 2
1.9 TECHNICAL SPECIFICATIONS
Model #
Color
Rate Cooling Capacity
Voltage, Frequency, Phase
Rated Current
Design Pressure
Refrigerant, Quantity
Plug Capacity
Plug Type
Cord Length
Dehumidifying Amount
Air Circulation Volume
Net Weight (Unit only)
Dimensions
KY-25/Y
Stainless Steel/White Metal
9000 BTU/hr
AC~115V/60Hz/1 PH
8.2A
Max/High 370 psi, Min/Low 150psi
R22/500g (17.6oz)
125V/15A
5-15P
6.43ft/1.96M
25.4oz/h / 0.75L/hour
5.67CMM/200CFM
24.75 kgs/54.56 lbs
13.8”L x 14”W x 31.42”H / 35.1cmL x 35.6cmW x 79.8cm H
NOTE:
The above data are obtained under the following conditions:
Cooling condition: Dry bulb/Wet bulb: 95°F/83°F (35°C/28.3°C) according to American standard
128-2001.
Operating Limits During Cooling
Maximum condition: Dry bulb/Wet bulb: 104°F/80°F (40°C/26.7°C)
Minimum condtion: Dry bulb/Wet bulb: 64.4°F/57.2°F (18°C/14°C)