Filter
Top Products
6.2 CLEANING OR REPLACING THE AIR FILTER
If the air filter is blocked with a lot of dust, the volume of airflow will be reduced and the cooling
effect will be lower. It is recommended to clean the filter once every two weeks or as needed.
A) Pull out the filter from the filter compartment in front of the unit.
B) Wash the air filter by immersing it gently into warm (about 104°F/40°C) water with a gentle
detergent. Rinse the filter and dry it thoroughly in a shaded place.
C) Place the filter back into the filter compartment after it is thoroughly dried.
D) If the filter is torn or unusable, order a new filter by calling the Sunbeam Customer Service
department at 1-877-383-6399 (8:30am-5:30pm E.S.T.).
SECTION 6
CARING FOR YOUR PORTABLE AIR CONDITIONER
18
6.3 EXTERNAL PLASTIC PARTS
A) Keep the unit from being exposed directly to the sun.
B) Clean the surface with a damp cloth.
C) For the Stainless Steel finished models, a good quality stainless steel cleaner should be used.
6.4 STORAGE AT THE END OF THE COOLING SEASON
A) On a warm day, turn the unit on in the FAN-ONLY
Mode for a couple of hours so that the inside can dry
out completely.
B) Turn off the unit and unplug the unit.
C) Empty the residual condensated water by unplugging
the LOWER WATER DRAINAGE CAP at the back
towards the bottom of the unit.
After connecting the
12’/3.65m white Drain Hose, ensure that the other end is
in a bucket or receptacle for gathering the water.
D) Discharge the Hot air duct and shorten it and pack it
in the box.
E) Clean the filter and dry it completely before fitting
back in place.
F) Cover the appliance to protect it from dust. It is
recommended that the unit be put back into its
original box and package.
G) The unit should be stored in a cool dry place. Do not
stack heavy objects on the top of the unit.
Figure 17
Lower drain port
6.1 MAINTENANCE
WARNING
• Make sure the power supply is switched off and the plug is pulled out of the power outlet
before performing any maintenance activities.
• Do not immerse the unit in water or other liquids.
• Do not pour liquids into the unit.
• Take special precaution to avoid the sharp cutting edges of some parts.
• Do not use any kind of chemical solvents to clean the unit, as they may deform the
unit cabinet.