State Industries SSED 5 Water Heater User Manual


 
7
LOCATING THE NEW WATER HEATER
APPROVALS
MODEL AND RATING
FACTS TO CONSIDER ABOUT THE LOCATION

is a very important consideration for the safety of the occupants in
the building and for the most economical use of the appliance.
Whether replacing an old water heater or putting the water heater in
a new location, the following critical points must be observed. The

           
necessary if levelling is required.
          
where leakage of the tank or connections will not result in

the structure.
3. The discharge opening of the temperature and pressure relief

or external to the building. In cold climates, it is recommended
that the discharge pipe be terminated at an adequate drain
inside the building.
 

Insulate hot and cold water piping where heat loss and condensation
may be a problem.

work to be performed through the front control panel.

30 inches in front for access to the unit.
The heater may be installed on or against combustible surfaces. The

The temperature of the space in which the water heater is installed

ASME

by Underwriters
