Speco Technologies SIPSD37X Home Security System User Manual


 
37X Speed Dome Camera 39/50
Swing Setup
SWING SETUP
------------------------
SWING NO. 1
1ST POS. NOT USED
2ND POS. NOT USED
SWING SPEED 30/SEC
CLEAR SWING CANCEL
RUN SWING
BACK
EXIT
z Swing
Number
[1~8]
Selects a Swing number to edit. If the
selected Swing is not defined, "NOT USED"
is displayed in the 1st Position and the 2nd
Position.
z 1st Position
2nd Position
[PRESET 1~128]
Sets the 2 positions for a Swing function. If
the selected preset is not defined,
"UNDEFINED" is displayed as shown
below.
When a swing function runs, the camera
moves from the preset assigned as the 1st
point to the preset assigned as the 2nd
point in CW(Clockwise) direction. Then
the camera moves from the preset
assigned as the 2nd point to the preset
assigned as the 1st point in CCW
(Counterclockwise) direction. In case that
the preset assigned as the 1st point and the
preset assigned as the 2nd point are same
or only 1 Preset position is assigned, the
camera turns on its axis by 360° in CW
direction and then it turns on its axis by
360° in CCW direction.
z Swing
Speed
[1°/sec. ~180°/sec.]
Defines Swing speed between the 2 Preset
positions from 1°/sec to 180°/sec
z Clear Swing [CANCEL/OK]
Deletes the data of the selected Swing.
z Run Swing Runs Swing for the test purposes to check
if it works properly.
SWING SETUP
------------------------
SWING NO. 1
1ST POS. PRESET5
2ND POS. NOT USED
UNDEFINED
OSD MENU 4