Filter
Top Products
37X Speed Dome Camera 21/50
Pattern
z Function This function is that the camera memorizes the path (mostly curve
path) by the joystick of the controller and revives the trajectory
operated by joystick as closely as possible.
MAX. 4 Patterns are programmable and Maximum 1200
communication commands can be programmed in a pattern.
z Setting Patterns A Pattern can be created by the following methods.
Method 1) <Set Pattern> [Pattern NO.]
{ The Pattern programming window appears on the monitor as
below.
EDIT PATTERN 1
[NEAR:SAVE /FAR:DELETE]
0/0/x1/N
{ The movement by Joystick and the preset movement can be
memorized in a pattern.
{ After a pattern is programmed, the remaining storage is
displayed in progress bar on the screen.
{ To save the recording, press NEAR key and to cancel, press
FAR key.
Method 2) Programming in OSD Menu : See the section “How to use OSD Menu”.
z Running Patterns
Method 1) <Run Pattern> [Pattern NO.]
Method 2) <Go Preset> [Pattern NO. + 130]
ex) Run Pattern 2 : <Run Pattern> [2]
ex) Run Pattern 2 : <Go Preset> [132]
z Deleting Patterns To delete Patterns, enter into OSD menu.
Note) When the system memorizes Patterns, the commands are stored in the momories, not
the positions of Pan/Tilt/Zoom. Hence there might be small differences between the original
path and the revived path by path type of Patterns. Note that it is not a problem in position
precision.
OPERATION 3