Filter
Top Products
14
SEKU 2000 A1
GB
IE
Handling and operation
NOTICE
See also "Operating Elements" on page 7.
►
In this chapter you receive important information for the handling and operation of the appliance.
Activate the ON/OFF switch
to turn the unit on. The fl ame replication lights up. Programme in the
desired brightness with the Dimmer
5
.
Then, turn the heater on with the switch
2
; the built-in fan starts to run and the heater is working at level
1 (1000 W).
Activate the additional switch
3
; the heating is now working at level 2 (2000 W).
Using the thermostat
4
, you can set it to the desired temperature. The heat settings switch themselves off
after reaching the set temperature range, and switch back on when it becomes cooler.
Switching the appliance on and off
Activate the ON/OFF switch to turn the appliance on.
Activate the ON/OFF switch
once again to turn the appliance off .
Maintenance
The maintenance of the appliance is limited to occasional external cleaning.
NOTICE
Keep the appliance, and in particular the ventilation grille, free from dust and dirt.
►
Changing the light bulbs
DANGER
Risk of electrocution!
Contact with electricity can be fatal!
Pay heed to the following safety information to avoid the risks of injury:
Switch the appliance off .
►
Before changing the bulb, unplug the appliance from the mains power source. ►
WARNING
Risk of injury from sharp edges!
When reaching in through the housing opening, there is a risk of injury from the
sharp edges on sheet metal housing and the refl ector mirrors.
Pay heed to the following safety information to avoid these risks:
Do not touch the edges of the housing and the refl ector mirror
►
11
.
Wear protective gloves if necessary.
►
Handling and operation/Maintenance