Filter
Top Products
11
Assembly
SEKU 2000 A1
GB
IE
Then, bring the front panel
4
and side panel
8
together at right angles, so that the locking pins
D
enter the holes on the right edge of the side panel.
When done, screw all three adapter sleeves
E
to the right with the screwdriver until the locking pins are
clamped into the adapter sleeves and the panels are seated fi rmly together and at right angles.
Step 3
Take the centre front panel
5
and lay it face down.
Then place four adapter sleeves
E
in the four large holes. Turn the adapter sleeves with the screwdriver
so that the arrows on the adapter sleeves each point to the outer edge of the centre front panel
5
.
Insert four double locking pins
C
in the upper holes on the front sides of the panel and turn the adapter
sleeves
E
with the screwdriver to the right until the locking pins are fi rmly secured.
Step 4
Now connect the so prepared centre front panel
5
with the side panels prepared in steps 1 and 2.
For this, insert two adapter sleeves
E
in the large holes in the side panels. Turn the adapter sleeves
E
with the screwdriver so that the arrows on the adapter sleeves each point to the outer edge of the side
panels.
Then, guide each of the double locking pins
C
of the centre front panel
5
into the corresponding holes
in the edges of the side panels.
When done, turn all four adapter sleeves
E
in the centre front panel
5
with the screwdriver to the right,
until all parts are at right angles to each other and fi rmly tightened.
E
5
C
C
E
E
5