Filter
Top Products
29
7.
Proceed to “8. Downloading the contents of the IRC programming to satellites”, see page 34
— Inline preset.
NOTE
•
The terminal numbers and machine numbers of the master and satellites must be entered into
the master list for IRC communications.
•
The terminal numbers and machine numbers of up to 64 machines (one master and 63
satellites) can be entered into the master list.
•
The terminal number should be within the range from 1 to 254 and the machine number from 1
to 999999.
•
A satellite can not perform inline communications unless its terminal and machine numbers
are present in the master list.
•
If a machine number which already exists in the master list is entered, an entry error will occur
even when the corresponding terminal number does not exist in the list.
•
Pressing the [ENTER] key sets the programmed terminal numbers and machine numbers
within the master’s list. Pressing the [CA/AT] key issues a receipt on the receipt/journal printer
when it exists.
•
The terminal numbers for remote printers is not preset.
(2) Deleting a machine from the master list
To delete a terminal number from the master list, proceed as follows:
1. Turn the mode switch to the PGM2 position.
2. Select “INLINE SETTING” and press the [ENTER] key. The INLINE SETTING menu will
open.
3. Press the [ENTER] key. The MASTER LIST window will appear.
4. Select the terminal to be deleted and press the [DEL] key.
5. The machine will ask you as follows: “ARE YOU SURE?” If you are sure to delete it,
select “YES.” If not, select “NO.”
6. Press the [CA/AT] key to complete the master list.
7. Proceed to “8. Downloading the contents of the IRC programming to satellites”, see
page 34 — Inline preset.
NOTE
•
You can delete any of the terminal numbers that are in the master list.
•
Deleting the master from the master list will inhibit all requests of the satellites from being
serviced.