Filter
Top Products
47
(2) Programming of the time-out time
The time-out value for receiving the data can be specified by the following procedure:
1. Enter the PGM2 mode from the mode selection window.
2. Select “2 SETTING” from the displayed menu.
The SETTING window will appear.
3. Select “22 MWS CONFIG” from the displayed menu.
The MWS CONFIG window will appear.
4. Touch the “TIME OUT” line and enter a number (1-255 (sec)) for the time-out time, and then touch the
[EXIT] key.
The DATA NOT SAVED SAVE IT? dialogue will appear.
• This value (time-out value) will depend upon the application. Please consult your authorized SHARP
dealer.
5. Select “1.SAVE.”
(3) Programming of the gateway number
The gateway number can be specified by the following procedure:
1. Enter the PGM2 mode from the mode selection window.
2. Select “2 SETTING” from the displayed menu.
The SETTING window will appear.
3. Select “22 MWS CONFIG” from the displayed menu.
The MWS CONFIG window will appear.
4. Touch the “G.W. ADDR. 4” line and enter a number (1-254) for gateway IP address 4, and then touch
the [ENTER] key.
• Entering a terminal number of the machine itself results in “ENTRY ERROR.”
• A number pre-entered in the “IP ADDRESS 4” line is not available for the gateway IP address 4.