Filter
Top Products
38
For the setup of your IRC system, please be sure to consult your authorized SHARP dealer.
(1) Setting the terminal number for the master and creating the master list
A master list can only be created on the pre-designated master.
1. Enter the PGM2 mode from the mode selection window.
2. Select “2 SETTING” from the displayed menu.
The SETTING window will appear.
3. Select “21 INLINE CONFIG” from the displayed menu.
The INLINE CONFIG window will appear.
4. Enter a terminal number (1–254) for the master in the “IP ADDRESS 4” line and carry out the
programming for BMA MACHINE NO.*, the SYSTEM RETRY function*, and LOOKUP ORDER*, and
then touch the [CONTINUE] key.
The MASTER LIST window will appear.
(*For programming for BMA MACHINE NO., the SYSTEM RETRY function and LOOKUP ORDER, see
pages 40–41.)
5. Enter a terminal number (1–254) for a machine in the IRC system in the “IP ADDRESS 4” line, and then
touch the [ENTER] key.
The “MACHINE No.” line will be selected for entry.
6. Enter the machine number (1–999999) of the machine and touch the [ENTER] key.
7. Repeat steps 5 to 6 for all machines in the IRC system.
Touch the [CONTINUE] to complete the master list.
• The terminal numbers and machine numbers of the master and satellites must be entered into
the master list for IRC communications.
• The terminal numbers and machine numbers of up to 32 machines (one master and 31
satellites) can be entered into the master list.
• The terminal number should be in the range from 1 to 254 and the machine number from 1 to
999999.
• No satellite can perform inline communications unless its terminal and machine numbers are
present in the master list.
• If a machine number which already exists in the master list is entered, an entry error will occur
even when the corresponding terminal number does not exist in the list.
• Even if a set of terminal and machine numbers that exists in the master list is entered, no error
will occur (the list will remain unchanged.)
NOTE
3.
Initial setting for the master and master list creating/updating