Filter
Top Products
Additional Equipments
Ward Control Unit (WCU): When fitted the WCU will allow
a group of circuits, which are designated a Ward, to be
Set and Unset using Exit and Entry routes separate from
the system. The WCU is connected to the outputs and
circuits of a REM or a NU and will require a separate 12V
supply.
Printer: An Epson printer P40-S may be connected
temporarily to the CP or to the SlB to provide printout
records. Other printers that accept RS232 serial data
maybepermanently connectedtotheSIB ifpermanent
records are required.
Power Supply Unit: All power can be supplied from the
TS2000CP internalPower SupplyUnit butin largesystems
it may be necessary to fit additional power supply units.
The PSU150 has been designed for use with the TS2000
system and consists of a PSU and battery (supplied
separately) and it may also have a Node Unit and a
Relay Unit fitted in its enclosure.
Output Modules (OM): If remote indicators or Mimic
Panels containing LEDs are required then Output
Modules type CPA6.OM may be connected to the CP.
EachOMunitwilldriveup toeightLEDs andtheunitsmay
be interconnected for large displays. The system may
be programmed so that the LEDs indicate circuit
condition or alarms and ward status if wards are
programmed.
Extension loudspeakers: The REM contain a small
sounder unit to provide an indication of the system
status. If the volume of the sounder is insufficient (e.g. a
louder exit sound is required) then an extension speaker
may be fitted to the NU and this will require a
Loudspeaker Drive Unit type LSD1 to be connected
between the NU and the loudspeaker. A separate 12V
power supply will also be required.
Relay Unit: The NU and REM programmable outputs will
provide current limited drive for various facilities but in
many cases it will be necessary to isolate the system
from theexternal equipmentby driving viarelays. Relay
Units type RM3A provide two relays, which may be
energised by NU or REM programmable outputs, and
whichprovide twosets of’clean’ changeover contacts.
The unit may be fitted separately or in a PSU150 case.
Remote Data Transfer
When fitted with a Digimodem type DC3M the system
may be programmed from a remote location, and log
data transferred to it, using a dedicated program
installed in a Personal Computer at that location. The
use of this facility is protected by a series of passcodes
and user menus.
496529 Issue A 3 of 20 TS2000
TS2000