Sears 625.34823 Home Safety Product User Manual


 
Read all steps, guides and rules carefully before
installing and using your new water filter. Follow all
steps exactly to correctly install. Failure to follow
them could cause personal injury or property damage.
Reading this book will also help you to get all of the
benefits from your water filter.
Check with your local publicworks department for
plumbing and sanitation codes. You must follow
their guides as you install your filter.
Protect the filter and piping from freezing, see page I
19. Damage fromfreezing voidsthefilter warrant.
Use only LEAD-FREE SOLDER AND FLUX, as re-
quired by Federal and State codes, when install-
ing soldered copper plumbing.
Your clarifyingfilter will clean yourwater as stated
below. It will not softenhard water or remove iron.
It will not purify pollutedwater or make it safe to
drink.
PLEASE READ AND COMPLY WITH THE
FOLLOWING GUIDES TO PREVENT DAMAGE.
TO THE FILTER OR OTHER PROPERTY, PER-
SONAL INJURY, OR POSSIBLE FATAL SHOCK.
THIS FILTER WORKS ON 24 VOLTS ONLY.
BE SURE TO USE THE TRANSFORMER INCLUD-
ED, AND PLUG IT INTO A 120V OUTLET.
Be sure the electric outlet for the
transformer is grounded the right way.
Unplug the transformer right away if the
power cable should become damaged or frayed.
Make repairs before plugging back into the
power outlet.
Always unplug the filter from electrical
power before removing outer valve covers.
Connect the filter to the houee COLD water
(1200 max.) pipe only. DO NOT CONNECT TO
HOT WATER.
When you see this signin the book, somethingcouldbedamaged, or someone hurt, ifthe guide isnot followed
exactly.
WHAT YOUR CLARIFYING FILTER WILL DO
A Sears Clarifying Filter takes sediments such as dirt,
sand, silt, clay, and fine organicmatterout of water. You
can see sediments in water by filling a clear drinking
glass. When held up to light, you can see the particles
floating inthe water, or settledto the bottomof the glass.
The filterisfilledwith"filter aggregate" mineral thattraps
and holds the sediments as the water flows through it.
The Clarifier is sometimes installed alone, but is often
followedby a wamrsoftener.Besidessofteningthe water,
the water softener catches sediments that may get
through the filter. Sears Water Analysis Laboratorywill
test your water and tell you what equipment you need
(see page 5).
NOTE: If you will install the clarifyingfilter along with a
Sears SolutionDispensing System, read the dispensing
system owners manual for treating a private well before
installing.
4