Filter
Top Products
I SECTION 6 I CARE OF YOUR FILTER
I
BEFORE YOU CALL FOR SERVICE
HELPFUL HINTS CHECKLIST...TO HELP YOU SAVE MONEY
By making a few easy checks, you can often avoid an unneeded service call. If your water filter fails to work,
check these things. If, after making the checks it still does not work right, call your Sears Service Department.
FILTER WILL NOT BACKWASH
(Water contains sediments, iron, dirt, sand, etc.)
HOUSE WATER PRESSURE LOW
_-] MANUAL BYPASS VALVE(S) IN BYPASS
POSITION - See FIG. 11, page 13. Move stem
in single bypass valve to SERVICE. In a
3-valve bypass, open the inlet and outlet valves, close
the bypass valve.
_'_ TRANSFORMER UNPLUGGED AT THE
WALL OUTLET, OR POWER CABLE
DISCONNECTED - Check for loss of power
and correct. Reset the times, then use the RECHARGE
NOW feature (See page 16).
I_ WELL PUMP PRESSURE SET TOO LOW -
Adjust to a MINIMUM of 20 psi.
I'_ BACKWASH NEEDED MORE OFTEN TO
KEEP FIL1;ER MINERAL BED CLEAN - Set
the timer for more recharges (See pages 15
and 16).
r_ FUSE BLOWN, CIRCUIT BREAKER POP-
PED, OR CIRCUIT SWITCHED OFF - Replace
fuse, reset circuit breaker, or switch circuit on.
Reset times and use the RECHARGE NOW feature.
NOTE: SEE "TIMER POWER-OUTAGE MEMORY,"
PAGE 17.
[] TIMER IN THE VACATION (VAC) POSITION
- Press the VACATION button once to return
the filter to service (page 16).
r-_ TIMER NOT PROGRAMMED FOR
RECHARGES - See pages 15 and 16 to select
and program a schedule. Use the RECHARGE
NOW feature.
[] VALVE DRAIN HOSE PLUGGED - Hose must
not have kinks, sharp bends, or any water flow
blockage. (See page 12.)
18.