Filter
Top Products
I SECTION 3 STEP BY STEP GUIDES TO INSTALL I
BYPASS VALVE ITEM NO. 42/65-3437 - If not
L
D. already done, put a light coating of silicone grease
or Vaseline on the bypass valve o-rings.
Push the bypass valve into the filter valve as far as
it will go (FIG. 5, 6 and 7). SNAP THE 2 LARGE
HOLDING CLIPS INTO PLACE, FROM THE TOP
DOWN AS SHOWN. BE SURE THEY SNAP FIRMLY
IN PLACE, SO THE BYPASS VALVE WILL NOT
PULL OUT. GO TO STEP 7.
IN
TURN BYPASS VALVE
UPStDF.-DOWN TO
CONNECT TO FLOOR
LEVEL PLUMBING
SIDE VIEW
/_-_CLIP
END VIEW
Valve Body
|ntet or Out_et
Of
Bypass Venire
(Push all the way in)
6, INSTALLING 3 VALVE BYPASS, OR SEARS
BYPASS VALVE, ITEM NO. 42/65 3436, AND
PIPES (FIG. 8).
Cut the house main water pipe where you wilt
a, connect the filter. Loosely put together pipe, fit-
tings, and the 3 valves or Sears special bypass
valve. Place valve(s) within easy reach.
IMPORTANT: WHEN LOOKING AT THE FRONT OF
THE FILTER, THE INLET IS ON THE RIGHT SIDE.
IF WATER IN YOUR HOUSE MAIN WATER PIPE
RUNS FROM LEFT TO RIGHT, BE SU RE TO USE A
_CROSS-OVER" AS SHOWN IN FIG. 2 AND 3,
PAGE 8.
INSTALLING BYPASS VALVE
ITEM NO. 42/65-3436, OR
3-VALVE BYPASS
SINGLE VALVE BYPASS
Filter
3-VALVE BYPASS
FiRer
inlet
If all pipe, fittings and valves fit together good,
b, tighten all threaded joints (use pipe dope on
outside threads), or solder atl joints following the
soldering tips on page 20.
10