Filter
Top Products
SECTION 5. CARE FOR THE MACHINE
_, Clean the Shuttle Race
This area must be kept tree of dust, lint and occasional tangled thread, Clean the shuttle race area about
every three months.
f
t
Center p_n oi
lhe shullle
Lever
Lever Bobbi_ _''_"
To Clear} the Shuttle Area:
1. Raise the needle bar to its highest point
and remove the bobbin case.
2. Push shuttle race levers aside. Lift
shuttle race cover and take shuttle out.
3. Clean the shuttle race with a lint brush.
4. Put a drop ol oil on the center pin of the
shuttle and shuttle race. Do not over-oil.
Shuttle driver
Lever_
Shuttle Race L
fOil here)
Lever
Pomled
Shultle
Shuttle Race
Cover
To Replace Shuttle Assembly:
1. Position shuttle race as illustrated so that shuttle
driver is forming half moon on the left side ot the
machine.
2. Hold shuttle by center pin and position shuttle so as
to form a half moon on the right side. Pointed hook
will be on the bottom,
3. Place shuttle race cover into place over shuttle
assembly,
4. Snap the levers back into the originaf position.
39