Filter
Top Products
Prepare the Top Thread
• Thread the Needle
The numbered steps above tollow the numbers
on the illustrations.
Dotted lines show places where the thread loops
and then is pulled tight.
SECTION 2. PREPARE THE MACHINE FOR SEWING
Raise take-up lever to its highest position by turning hand wheel toward you,
Raise presser toot lever,
Place spool on spool pin as shown, with thread coming from the back ot the spool,
(_ Draw thread into thread guide using both hands.
(_ While holding thread near spool, draw thread down into the tension area and then around the check
spring holder,
Firmly draw thread up and through take-up lever from right to left.
4(4(QDraw thread down and slip it into left side needle bar thread guide,
(_) Thread needle trom front to back,
NOTE: You may want to cut the end of thread with sharp scissors for easier needle threading,
11