Filter
Top Products
SECTION 3. REARNTHE STITCHES
Slider
Wrong stde
of [abric
• J
8. Open the zipper.
9, Lower the presser toot and stitch the
rest of the seam.
f
INVISIBLE ZIPPER AND CORDING
10. Close the zipper and turn the tabric
right side up,
fNVIStBLE ZIPPER
Adjust the toot so the needle is sewing through
the center hole of the tool and one groove o! the
toot is nding on the teeth of the zipper as shown.
Follow the zipper manutacturer's instructions.
After zipper has been inserted, finish sewing
seam by shifting toot to s_de position sewing
through side notch.
CORDING
Foot can also be used to make cording for
slipcovers etc. Cover a cord with a str_p of bias
tabnc and sew as shown.
NOTE:
Use "'Low Bar Sewing Machine ZIPPER
FOOT" (6757) tot "'invisible z_pper'" and
"cording", which can be obtained at any
Sears retail store.
11. To sew the right side of the zipper,
set the zipper toot on the right side
of the needle.
12. Stitch across and below the bottom
ot the zipper.
13, Turn the corner and continue to
guide the foot along the zipper
teeth, as shown.
Stitch through the fabric and zipper
tape.
f
of labnc "',
14. Stop about 2"" from the top ol the
zipper.
15. Lower the needle into the tabric
and raise the presser foot.
16. Remove the basting stitches and
open the zipper.
17. Lower the toot and stitch the rest el
the seam. Make sure the fold is
even.
2I