Sanyo UV Carbon Monoxide Alarm User Manual


 
111
20
BASIC PARAMETERS
Setting the chamber temperature and CO
2
density
The setting procedure for the chamber temperature and CO
2
density are given below. (Default settings:
Chamber temperature: 37
o
C, CO
2
density: 0%)
The Incubator automatically starts operation using these settings after the power is turned ON.
1. From the Top Display, press the MENU Key to access the menu. Select Set and press the ENTER
Key.
2. The Stand-By Setting Display will be displayed. Set the parameters.
The setting ranges of the parameters are as follows:
ƔTemperature: 0 to 50
o
C. To 37.0
o
C, enter 370.
ƔCO
2
density: 0 to 20%. To set 5.0%, enter 050.
3. Press the MENU Key to display the menu after setting the parameters. Select OK and press the
ENTER Key. The settings will be saved.
Note:
When starting the Incubator for the first time or after not using it for an extended period of time, allow at
least 4 hours for the chamber temperature, humidity, and CO
2
sensor to become stable after setting the
desired chamber temperature at a 0% CO
2
density. Then change the setting to the desired CO
2
density.
1
S t a n d - by S e t t ing
2
T e m p e r a t u r e
3 7 . 0
o
C ( 0. 0
o
C- 50. 0
o
C )
3
C O 2 D e n s i t y 5 . 0 %
(0.0% - 20. 0 % )
4
5
K e y L o c k 0
( 0 . U n l o c k 1 . L o c k )
6
H i g h L i m i t 5 2 . 0
o
C
M E N U
O K
C a n c e l
1
T e
m p 3 7 . 0
o
C C O 2 5 . 0 %
2
3
4
5
S t a t u s
6
O K
7
㧟㧣㧜
㧡㧜
M E N U
S e t
L o g
T o o l s