Filter
Top Products
COLOR DOME CAMERA User’s Manual
15
COLOR DOME CAMERA User’s Manual
14
Operating Your Camera
Connection
Connecting to Power
• Use AC 24V / 300mA or DC 12V / 500mA power source.
• For DC power as the voltage drop according to the length of the cable in the
above table, a camera may malfunction if there is an excessively long cable run.
Resistance of copper wire [at 20C˚ (68˚F)]
* Voltage for camera operation: 12V DC ±10%
* Voltage drops in the above table are variable according to types of cable manufacturer.
For DC Power Type
Copper wire size (AWG)
#24(0.22mm
2
)#22(0.33mm
2
)#20(0.52mm
2
)#18(0.83mm
2
)
Resistance ( Ω/ m) 0.078 0.050 0.030 0.018
Voltage Drop (V/m) 0.028 0.018 0.011 0.006
• Be sure to connect power only after all the installation is complete.
• Note that AC or DC adaptor is not supplied with camera.
• Use the UL listed, class 2 power transformer of AC 24V adaptor.
• Ground should be connected to the GND terminal.
Notes
Configuration of The Menu
SETUP MENU
CAMERA ID (see page 17)
• OFF • ON
BACKLIGHT (see page 20)
• WDR • BLC • OFF
WHITE BAL. (see page 21)
• W-ATW • S-ATW • AWC • MANUAL
MOTION DET. (see page 22)
• OFF • MD1 • MD2
IRIS LEVEL CONTROL (see page 25)
• LEVEL
SHUTTER (see page 26)
• OFF • 1/100 (1/120) • MANUAL
SENSE UP (see page 27)
• Auto • OFF
GAIN (see page 28)
• OFF • AGC-L • AGC-H
SSNR (see page 28)
• OFF • LOW • MIDDLE • HIGH
SPECIAL (see page 30)
• COLOR • SYNC • PRIVACY • RESET
• END • EXIT
EXIT