Filter
Top Products
Operating Your Camera
COLOR DOME CAMERA User’s Manual
25
COLOR DOME CAMERA User’s Manual
24
· When completed, press SET button.
MD2: Your camera detects object’s motion by the variation of brightness, so
this mode is very useful for night or observing large moving object.
Also MD2 enables you to set seperated areas.
Press SET button.
Move the arrow indicator to ‘AREA SET’ like MD1.
Set the areas you want to observe of the 48 areas.
· Move the cursor to the area you want to observe, and then press the SET button.
· After setting, move the cursor to edge in any direction and then press the button
just one more, let ‘END’ blink.
· Press the SET button.
•
If you set some areas of 48 areas, your camera detects the object’s motion within
the areas you set.
Notes
· Move the arrow indicator to 'TOP' using the UP or DOWN button and increase or
decrease the value using the LEFT or RIGHT button. Repeat the procedure for
bottom, left and right.
Maximum
18
13
Minimum
6
5
Tips on Using the Motion Detection Feature
• As you increase or decrease MD LEVEL, the areas’ sensitivity is increased or
decreased for object.
• After selecting zone and sensitivity, perform a test operation to make sure it
works properly.
• If the lighting flickers, the motion detection feature might not work properly.
• The object should occupy 10% or more of its zone. The bigger the object, the
higher sensitivity.
• If the brightness of an object changes rapidly by sudden lighting change, the
camera may detect it as a motion.
• Your camera can count up to 999. If you reset your camera with selecting
‘RESET’ in SPECIAL menu or turn it off and on, your camera’ll count up from 0.
• When this feature is activated, another algorithm may take more time to be operated.
• This system does not guarantee prevention of fires or thefts. The manufacturer
is not responsible for any accident or damage.
IRIS LEVEL CONTROL
You can control the brightness of the screen.
1. Press the SET button to display the setup menu and move the arrow indicator
to 'IRIS' using the UP or DOWN button and press SET button.
2. Set ‘LEVEL’ to the desired brightness using LEFT or RIGHT button.
3. When completed move the arrow indicator to ‘END’ and press the SET button.
SETUP
CAMERA ID OFF
BACKLIGHT WDR
WHITE BAL. W-ATW
MOTION DET. OFF
IRIS LEVEL
SHUTTER OFF