Filter
Top Products
Troubleshooting
Check this list of possible problems and solutions before bringing your vacuum to a service center.
This Vacuum cleaner is approved the following.
EMC Directive: 89/336/EEC, 92/31/EEC and 93/68/EEC
Low Voltage Safety Directive: 73/23/EEC and 93/68/EEC
Problem
C
LEANER WON
’
T TURN ON
• Not firmly plugged in.
• No voltage in wall plug.
• Blown fuse or tripped breaker.
• On/Off switch not turned on.
C
LEANER WON
’
TPICKUP
• Circuit breaker tripped.
• Agitator brush rolls worn.
• Dirt cup full.
• Incorrect carpet height setting.
• HEPA cartridge filter clogged.
• Pre-filter clogged.
• Dirt cup not properly installed.
• Filter assembly not assembled properly.
• Blockage in hose(or air flow passage).
• Broken belt.
• Hose not inserted fully.
A
BNORMAL SOUND
• Strange sound like air rushes
Possible solution
• Plug unit in firmly.
• Check fuse or breaker.
• Replace fuse or reset breaker.
• Slide to on.
• Tighten the screw of the handle.
• Reset circuit breaker.
• Replace brush rolls.
• Empty dirt cup.
• Move nozzle control knob to lower settings.
• Clear HEPA cartridge filter by either tapping the side
of the dirt cup.
• Clean pre-filter.
• Position dirt cup properly.
• Ensure that filter assembly is positioned properly.
• Clear blockage.
• Replace belt.
• Insert hose.
• Check for clogs.
1313