Filter
Top Products
30_ I/O Time Setup
I/O time setup
TO SPECIFY THE OUTPUT TIME IF THE CARD IS NOT AUTHENTICATED
You can specify the output time if an unregistered card or PIN number fails in getting authenticated.
Present the Master Card to the device.
Press Button
2
twice and press
ENT
.
Refer to the output port table on page 29 and specify a desired output mode.
If you want the alarm relay alone to operate in normal and Secure modes for
an unauthenticated card, select the
<
5
2
> buttons and press
ENT
.
Enter the two-digit door relay output time and press
ENT
.
Enter the two-digit alarm relay output time and press
ENT
.
Enter the two-digit TTL output time and press
ENT
.
You can specify a two-digit time from 00 to 99 seconds.
By default, only the alarm relay operates for “02” seconds in normal and
Secure modes.
Other output ports that are not specifi ed for the output mode will not be activated. For instance, if you set the output
mode to [5][2] and assign the operation time for each output device by following the steps 4, 5, and 6 above, only the
alarm relay will operate.
TO SPECIFY THE DURESS TTL OUTPUT
If you enter the Duress code and present a registered card, the TTL output operates. Specify the TTL operation time for
this purpose. (For the Duress code, refer to Duress Alarm on page 24.)
Present the Master Card to the device.
Press Button
3
and Button
0
in sequence and press
ENT
.
Specify the two-digit TTL output time (unit: second) and press
ENT
.
The default is set to “03” second.
You can specify a time from 00 to 99 seconds.
1.
2.
3.
•
4.
5.
6.
•
M
1.
2.
3.
•
X Y Z
[ \ ]
^ _ `
lzj lu{
W
i
zzhTzYWWW
tGj
X Y Z
[ \ ]
^ _ `
lzj lu{
W
i
zzhTzYWWW
X Y Z
[ \ ]
^ _ `
lzj lu{
W
i
zzhTzYWWW
tGj
X Y Z
[ \ ]
^ _ `
lzj lu{
W
i
zzhTzYWWW