Filter
Top Products
16_ Initialization
initialization
WIEGAND OUTPUT SETUP
You can transfer data of the card read by SSA-S2000 in the 26-bit Wiegand output format.
Enabling this function will disable the TTL output and the chime bell sound.
To enable the 26-bit Wiegand output, you must manipulate the switch panel (SW1 and SW2) on the rear of the
product.
See the table below to make adjustment as needed.
Changing Output
SW1 #1 SW1 #2 SW2 #1 SW2 #2
Orange line with white stripes Brown line with white stripes
ON OFF ON OFF TTL Output Chime Bell Output
OFF ON OFF ON Wiegand Data0 Wiegand Data1
In the 26-bit Wiegand output mode, you can not initialize the product by short-circuiting cables.
INITIALIZATION
If you have the Master Card registered, you can use it to initialize the device.
Present the Master Card to the device.
Press the
9
button twice and press
ENT
.
The system will restore the factory default settings with all LED indicators
blinking.
Initializing the system will lose all data.
If the product works abnormally, use initialization to restore the default settings.
1.
2.
❖
J
1.
2.
3.
M
X Y Z
[ \ ]
^ _ `
lzj lu{
W
i
zzhTzYWWW
tGj
X Y Z
[ \ ]
^ _ `
lzj lu{
W
i
zzhTzYWWW