Filter
Top Products
24_ Basic Setup
basic setup
DURESS ALARM
If you are forced to open the door under the control of a criminal such as a robber, enter the predefi ned password with the
number of your registered card (or PIN), which outputs the emergency TTL signal.
Present the Master Card to the device.
Press Button
2
and Button
9
in sequence and press
ENT
.
Enter the two-digit Duress code and press
ENT
The default code is set to “00”. However, the number “77” can not be used
because it is set for the Secure mode.
TO SPECIFY THE RETRY COUNT FOR AN UNREGISTERED ID
You can specify the retry count for authentication with an unregistered card or PIN.
If the retry count exceeds the set limit, the keypad input will be suspended for the next one minute. (You can specify the
keypad input suspension time in “To specify the keypad input suspension time if the retry count with an unregistered ID
exceeds the limit” on page 25.)
Present the Master Card to the device.
Press Button
8
,
2
and Button
ENT
in sequence and press ENT.
Enter the two-digit retry count and press
ENT
You can specify a number from 00 to 99.
The retry count for an unregistered ID is defaulted to “05”.
1.
2.
3.
•
1.
2.
3.
•
•
X Y Z
[ \ ]
^ _ `
lzj lu{
W
i
zzhTzYWWW
tGj
X Y Z
[ \ ]
^ _ `
lzj lu{
W
i
zzhTzYWWW
X Y Z
[ \ ]
^ _ `
lzj lu{
W
i
zzhTzYWWW
tGj
X Y Z
[ \ ]
^ _ `
lzj lu{
W
i
zzhTzYWWW