Filter
Top Products
SECTION 5: HEATER INSTALLATION
9
SECTION 5: HEATER INSTALLATION
5.1 General
Heaters are designed for installation above 2.5 m.
These heaters must be installed within the heated
space. Duct delivery systems are not permitted with
axial fans.
5.2 Handling
All CTU heaters are supplied secured to a wooden
pallet and shrink wrapped. Use the pallet to support
the heater during handling and installation. When
handling or supporting the heater from below,
ensure that the weight is taken at the support points.
5.3 Shelf Mounting and Suspension
WARNING
Crush Hazard
Use 10 mm steel drop rod
minimum.
Failure of the supports can
result in death, injury
or property damage.
For typical suspension See Page 9, Figure 2.
Figure 2: Suspension Methods
10 mm
Steel
Drop Rod
Washer
Nut
Unistrut
Channel Nut
Cone Point
Set Pin
Window
Clamp
Unistrut
10 mm
Steel
Drop Rod
Nut
Washer
Riv
Nut
Support Points
Insure all suspension hardware
is torqued to a minimum
of 27 Nm (20 ft lbs)