Filter
Top Products
– 16 –
OPERATING THE TIMER(S)
Before operating the Timer(s), the clock time must be correct, and a starting time and finishing time for
the Timer(s) must be programmed. See pages 14 and 15. The two Timers operate in the same way.
This heater does not commence operation at the programmed starting time. It will attempt to heat a
room by the programmed starting time. See Pre-heat page 17, for further explanation.
If there is a power failure, the system memory will retain the Timer programs, and the clock will stop at
the time the power goes off. The clock will start again when the power comes back on, but the time will
be slow by the duration of the power failure. To set the clock to the correct time after the power has
come back on, simply follow the instructions on page 14.
1
To select the Timer(s) to commence heating:
Check the time shown on the Digital Display is
correct. See page 14. Check the ON and OFF
times, for both Timers if neccessary, see page 15.
AM
PM
Set Room
Temp
Time
2
Press the ON-OFF button to operate the heater. The
On indicator will glow green and the heater will begin
to operate. Select the desired temperature setting.
Filter
ON / OFF
ON
3
Press the Timer 1 and/or Timer 2 button(s).
The Timer indicator(s) will glow and the heater will
remain on standby until one hour prior to the time
programmed into the selected Timer(s) is reached.
When this time is reached, the Timer indicator will
flash and the heater will operate. The ON indicator
glows red when the heater commences operation.
Child Lock
Timer 1
Economy
Timer 2 Override
SET AND FORGET OPERATION
Your heater can be operated to alternate between Timers automatically during cold weather by selecting Timer
1 and Timer 2 together. Both Timer indicators will glow. The appliance will remain on standby at intervals
between the programmed finishing and starting times of each Timer. While the heater is operating during
programmed intervals the Timer indicator will flash.