Filter
Top Products
– 15 –
PROGRAMMING THE ON/OFF TIMER(S)
Before programming the Timers you must ensure that the clock has been set to the correct time.
See page 14.
TIMER 2 is programmed in the same way, remember to ensure that the Timer 2 indicator is flashing
when you programme in the desired setting.
The Timers can be programmed to operate for any two periods in any 24 hours. Turn to next page to
operate the dual timer.
The programmed time must be selected and locked-in within one minute of the On Timer indicators
flashing otherwise the programmed times will not be retained in the system memory.
1
Press the Set Times button twice. The Digital Display
will show AM 6:00. Timer 1 indicator will flash.
AM
PM
Set Room
Temp
Time
Set times
Clock
Timer 1
Timer 2
on off
2 Override
AM
PM
Set Room
Temp
Time
Set times
Clock
Timer 1
Timer 2
on off
2
Press the “” button until AM 7:00 appears, release
the button, then press it again until AM 7:10 appears.
(Press the “” button if you go past AM 7:10.)
AM
PM
Set Room
Temp
Time
Set times
Clock
Timer 1
Timer 2
on off
3
Press the Set Times button again, the Timer 1 OFF
indicator will flash. Press the “” button until AM
9:00 appears.
AM
PM
Set Room
Temp
Time
Set times
Clock
Timer 1
Timer 2
on off
4
Press the Set Times button three times to lock in the
programmed time. The Digital Display will show the
current time. A small indicator on the Digital Display
will flash to show that the Display has returned to the
clock.
AM
PM
Set Room
Temp
Time
Set times
Clock
Timer 1
Timer 2
on off
As an example let’s programme Timer 1 to heat the room by 7:10 AM and finish at 9:00 AM.
TURN TO NEXT PAGE TO OPERATE THE TIMERS.